Set "Sport-12" - Zenitco

Brand: Zenitco
Product Code: ZNT-SetSport-12
Personaldiscount -15 %
Sale
TOP

Time left to buy:

Short descriptio


    The "Sport-12" kit is designed to replace the standard AK-12 handguard and carbines based on it (TR3).    The "Sport-12" set has six Basis rails that allow the installation of additional equipment compatible with the... Read more...

Available Options


$649.00 $551.65

  • Availability: Pre-Order


    The "Sport-12" kit is designed to replace the standard AK-12 handguard and carbines based on it (TR3).

    The "Sport-12" set has six Basis rails that allow the installation of additional equipment compatible with the Basis directly on the forearm (stops, swivels, buttons, wire clamps, pads, handles, additional Picatinny rails). To install equipment compatible with Picatinny rail, it is possible to install additional Picatinny rails (purchased separately) B-2, B-2L, , B-2M, B-2U anywhere on the Basis rail.
 
Advantages in operation:
  • strength;
  • provides a comfortable grip;
  • improves the cooling of the barrel of the weapon;
  • makes it possible to mount additional equipment.
Specifications:
Material: aluminum alloy D16T.
Weight: 265 + 10g
Set length: 265mm
Working range of ambient air temperatures: from -50 to +50 0C.
Warranty period of storage and operation of the product: 60 months.

Delivery set:
Top bracket "Sport-12" 1 PC.
Bottom bracket "Sport-12" 1 PC.
Axis 1 PC.
Screw 5x7 4 things.
Instruction manual 1 pc.

To install the Sport-12 kit on a weapon, you must:
1. Disconnect the standard fore-end with an overlay on the gas outlet tube.
2. Install the lower bracket "Sport-12" instead of the standard forearm. For this:
2.1. Place the rear end of the forearm in the receiver;
2.2. Place the lug on the barrel into the groove on the inside of the forearm. At the same time, move the standard swivel to the side so that it does not interfere;
2.3. Put a spacer on the upper end of the forearm, hammer the forearm through the spacer into the receiver. In this case, the protrusion on the barrel, as if on rails, should be positioned in the groove in the inner part of the forearm. It is unacceptable to cut the forearm;
2.4. Unscrew the axle included in the kit. Drive it into the hole for the axle. Screw on the back.
3. Install the upper bracket "Sport-12", tighten 4 screws at the junction of the upper and lower brackets;
4. Close the receiver cover lock lever.

The rigidity of the landing of the forearm and the brackets included in the kit determines the rigidity of the attachment of the sights, which affects the accuracy of the shot.

Write a review

Note: HTML is not translated!
    Bad           Good