Bracket B-51 - Zenitco

Brand: Zenitco
Product Code: ZNT-0067
Personaldiscount -15 %
Sale
TOP

Time left to buy:

Short descriptio


Bracket B-51 is a set of solid-milled products made of alloy D16T with a black or desert color coating. Bracket B-51 is compatible with PK, PKM, PKP machine guns. Mounted on the receiver cover boxes of a Kalashnikov ma... Read more...

Available Options


$639.00 $543.15

  • Availability: In Stock


Bracket B-51 is a set of solid-milled products made of alloy D16T with a black or desert color coating.

Bracket B-51 is compatible with PK, PKM, PKP machine guns.

Mounted on the receiver cover boxes of a Kalashnikov machine gun by replacing the standard hinge axis of the receiver cover with an axis supplied with the B-51 bracket.

The installed B-51 bracket forms a Picatinny rail 19 numbered cells over the receiver cover of the Kalashnikov machine gun, which does not overlap aiming line when using standard mechanical sighting devices.

Weight: 225 ± 5 g

Dimensions : (257x59x62) ± 5 mm

Working range of ambient temperatures: from -50 ° С to + 50 ° С

Guaranteed storage and operation period: 60 months


Completeness of delivery:
Bracket B-51 1 piece
Hex key 1 pc
Spacer 1 pc
Axle punch 1 piece
Axle 1 piece
Washers 2 pcs
Cotter pin 2 pcs
Operation manual 1 pc


To install the B-51 bracket on weapons needed:

1. Install the supplied axle drift at the stop to the standard receiver cover axis perpendicular to the weapon axis and parallel to the floor, carefully dismantle the standard receiver cover axis with a hammer, and replace the supplied drift. It is unacceptable to knock out a standard axle without a punch! Something must necessarily take the place of the standard axle.

2. Install the B-51 bracket above the receiver so that the stops in its rear part are located below the rear sight cover, and the side holes located on the left and right of the front of the B-51 bracket are aligned with the hole in which the drift has already been installed, and through them visually traced the punch of the axle of the receiver cover

3. Install the supplied receiver cover axis on the left side of the receiver into the side hole of the B-51 bracket so that it is perpendicular to the weapon axis and parallel to the floor, carefully using a hammer to dismantle the drift axle installed instead of the standard receiver cover axis

4. Install a washer on the axle, and a cotter pin in the axle hole, and pin it

5. Tighten the screw (under the number "9"), pressing the bracket from the receiver cover

ATTENTION !!! All screws in bracket B-51 have a right-hand (standard) thread. To avoid product failure, tighten and unscrew the screws very carefully, fully inserting the wrench into the screw.

For more detailed illustrated instructions, see the instruction manual.

Write a review

Note: HTML is not translated!
    Bad           Good