The costume consists of a jacket and trousers. Jacket length - to the hips, optimal for placement in vehicles, armored vehicles and for operations in a limited volume. The property carried in the jacket is distributed in ten pockets. Two vertical, welt-in “frame” pockets are located on the top of the shelves and fastened with a zipper. Two patch volume pockets are placed on the top of the shelves, and fastened with a button. Two patch volume pockets are located at the bottom of the shelves and are shifted to the back - so as not to interfere with crawling, lying down, being placed in cars and armored vehicles. Under the flap of the left pocket is an additional pocket for pens and pencils. Valves of patch pockets of volumetric pockets of shelves are grinded with burlap and when fastened with a secret button, they are wrapped - this valve design eliminates the loss of objects. Two additional patch pockets are placed on the upper part of the sleeves. On a jacket lining two internal patchpockets are placed. A stand-up collar protects the neck from abrasions with a body armor collar and an automatic belt. The top of the shelves and the back of the top of the jacket with yoke from the second layer of fabric - to protect against abrasion. Removable epaulettes are attached to the coquette. Sleeves are reinforced with a second layer of fabric on the elbows. At the waist and bottom, the jacket is regulated by a cord threaded into the wings, the bottom adjustment cord is fixed with a plastic stopper. The bottom of the sleeves is adjustable with buttons fastened with buttons, the loops of the straps are closed. For ventilation, mesh gussets are sewn into the armholes of the sleeves. Straight pants with a wide quilted belt, reinforced with a second layer of fabric on the knees and back. The belt is adjustable in volume by a cord threaded into the wings and side ties - elastic bands. The belt is equipped with six loops for a waist belt and loops for special removable aids with hooks. The bottom is regulated by elastic bands. In the lower part of the trousers, inside parts are sewn with special internal parts - “anthers”, tucked into boots to protect against dust and small stones getting inside. To place the necessary property, six pockets are used - two volumetric overheads with flaps on the back, two welt-hole frames in the upper part of the hips, two lateral overheads on the hips with folds and a cord tie - elastic bands with plastic stoppers. The suit is assembled with locks with double chain stitches. Elements subjected to increased load are additionally reinforced with special clips. The costume is made of mixed fabric (50% cotton 50% polyester) plain weaving, with a density of 220 g / m² with reinforcing thread every 10 mm. Deforming dyeing of fabric with lightfast dyes that are not decryptable in the infrared range.