The suit includes a jacket - a parka with a hood, trousers. Details of the costume are made of dense cotton linen fabric used for the production of army tents. Jacket - parka provides protection from strong winds due to the design of the hood and the internal windproof trims and an apron. The strap is sewn on the inside of the left shelf and fastens with buttons on the loops located on the right shelf. An additional wind protection is provided by a supine clasp, stitched to the left shelf. The outer placket is buttoned with fabric legs. The windproof apron is adjustable in volume by a rubber braid in the wings. The jacket is adjustable at the waist with a cord in the wings. The bottom of the sleeves, with special loops for the fingers, is adjustable in volume by ties from rubber bands. The bottom of the jacket is regulated by the cord of the wings, the cord clamps are located inside the lower pockets of the shelves. A hood of two parts, adjustable in volume by two cords in the wings with plastic clips, the free ends of the cord are threaded into special pockets - straps. The jacket is equipped with a special removable strap that prevents the jacket from bullying up. The jacket has seven pockets - two patch pockets on the sleeves and four welt pockets with flaps on the shelves - the lower part of the yoke serves as the valves of the upper pockets. The lower pockets of the shelves are placed vertically, for ease of access to property, when wearing a transport vest. On the burlap of the upper welt pockets there are internal pockets with waterproof liners. A special patch pocket made of polyester mesh is placed on the lower, inner side of the back, for a heat-insulating mat - a pallet. The coquette of the back and shelves, the second layer of fabric on the elbow bends and the bottom of the sleeves are made of polyester fabric. Pants with a wide belt, internal aprons - anthers are tucked into boots and prevent sand, snow, small stones from getting inside. In order not to hamper the movements in the side seams, two folds on each side are made at the level of the knees. At the back, on the knees and on the inside of the ankles, the trousers are reinforced with a second layer of polyester fabric. The trouser belt is adjustable in volume by side ties made of rubber braid, a cord in the wings or a wide belt threaded into the loops. Trousers are equipped with six pockets: four patch pockets, voluminous with protection against falling objects and two welt holes. Pants can be equipped with special removable aids, for this, special loops for hooks are sewn on the sides of the belt.